Technical Parameters
60 mm 130 mm 31 mm ≈87.25 mm ≈72.6 mm ≈104.8 mm 55 mm min.2.1 mm min.1.1 mm min.72 mm max.118 mm max.123 mm max.2 mm max.1 mm SKF Explorer 104 kN 76.5 kN 3.2 kN 6 300 r/min 6 700 r/min 0.0846 0.1 1.14 0.35 0.26 0.57 0.57 0.52 0.55 0.93Dimensions
d Bore diameter D Outside diameter B Width d1 Shoulder diameter of inner ring (large side face) d2 Shoulder diameter of inner ring (small side face) D1 Shoulder diameter of outer ring (large side face) a Distance side face to pressure point r1,2 Chamfer dimension r3,4 Chamfer dimension Abutment dimensions
da Diameter of shaft abutment Da Abutment diameter housing Db Diameter of housing abutment ra Radius of fillet rb Radius of fillet Calculation data
SKF performance class Basic dynamic load rating C Basic static load rating C0 Fatigue load limit Pu Reference speed Limiting speed Minimum axial load factor A Minimum radial load factor kr Limiting value e Calculation factor (single, tandem) X Calculation factor (single, tandem) Y0 Calculation factor (single, tandem) Y2 Calculation factor (back-to-back, face-to-face) X Calculation factor (back-to-back, face-to-face) Y0 Calculation factor (back-to-back, face-to-face) Y1 Calculation factor (back-to-back, face-to-face) Y2
Tolerances and clearances
General bearing specifications
Tolerances: Normal (metric), P6, P5, Normal (inch)
Internal clearance: CA+CB+CC, G
Preload: GA+GB+GC
Bearing interfaces
Seat tolerances for standard conditions
Tolerances and resultant fit
Our factory

Warehouse

Warehouse

Warehouse

Warehouse
Products Description
Single row angular contact ball bearing
These single row angular contact ball bearings can accommodate radial and axial loads acting simultaneously, where the axial load acts in one direction only. They can operate at high speeds and, depending on the variant, even very high speeds. They are more suitable than deep groove ball bearings for supporting large axial forces acting in one direction.
High-speed capability
Accommodate relatively high radial loads and large unilateral axial loads